roll forming machine
Call Us
0086 317 8312992
Opening Hours
24hours everyday
High-altitude And Join-hidden Roof Panel Equipment Home > High-altitude And Join-hidden Roof Panel Equipment
Automatic Rolling Machine 470 Joint Hidden Forming Machine
  • Automatic Rolling Machine 470 Joint Hidden Forming Machine
  • Automatic Rolling Machine 470 Joint Hidden Forming Machine
  • Automatic Rolling Machine 470 Joint Hidden Forming Machine
  • Automatic Rolling Machine 470 Joint Hidden Forming Machine
  • Automatic Rolling Machine 470 Joint Hidden Forming Machine

Automatic Rolling Machine 470 Joint Hidden Forming Machine

Item No.: JH1
Automatic Rolling Machine Joint Hidden Forming Machine
$28000.00
INQUIRY

Automatic Rolling Machine Joint Hidden Forming Machine

 

 

1: Configuration

 Uncoiler 1 set

PLC control system 1 set

Hydraulic cutting system: 1 set

Collection table  1 set

 

2Working Process Flow:

Uncoiling-Coil feeding-Guiding-Roll Forming-Punching (if needed) - Cutting-Collection table

 Automatic Rolling Machine Joint Hidden Forming Machine

3: Technical Parameters: 

 

A: Power supply:

380V, 3 phases, 50 or 60 Hz (can be adjusted according to actual power supply conditions in different countries)

Main motor power: 5.5KW

Pump power: 4kw

 

B:Uncoiler:

Inner diameter: 500mm

Outer diameter: 1100mm 
loading weight: 5t

 Automatic Rolling Machine Joint Hidden Forming Machine

C:Forming part: 

Feeding thickness: 0.3-1.0mm

Feeding width: 1100mm

Forming speed: 8-12m/min

Cutting Deviation: 10m±1mm

No. of Roller station: 11-16

Roller material: Cr12

Material of shaft: 45# steel with heat treatment

Diameter of shaft: 70mm

 

D:Hydraulic System:

Hydraulic pressure: 12-30 Mpa

Cutter material: Cr12

 

E:Control system:

Full-automatic NC-PLC control system

Control channel: Colored touch screen

 

Maintenance of roll forming machine

For a roll forming machine, good maintenance is a crucial element to improve machine working efficiency and extend its service life. Following are some tips on machine maintenance: 
 

Filter

1 each oil change, filters should be replaced or thoroughly cleaned; 
2 air filter of the fuel tank should be checked and cleaned every three months better to be replaced each year.
3 when there is alarm or oil filter is not clean, filter should be replaced; 
 

Hydraulic components

1 Hydraulic system should be cleaned each month, (including the base board, valve, motor, pump and oil pipe.) to keep dust off, but detergent should not be used.
2 When the new machine has been used for one month, user should check possible deformation of oil pipe and replace the deformed one. When used for two month, all connections of components should be tightened and this should be done after the machine is turn off and there is no system pressure.

Review